User's Manual

Character bar E shows the letters still
available for selection in black D. These
can be selected. In the example, the letter
A is highlighted G. The characters availa-
ble depend on the entry made by the user
so far and the data contained in the digital
map. Characters that are no longer availa-
ble are shown in grey C.
X
Select E, R, L, I, N in succession, confirming
each by pressing W.
Entering characters using the number
keypad
X
To enter the letter B: press the l num-
ber key twice in quick succession.
The
character appears at the bottom of the
display when the key is pressed. The first
available letter is highlighted.
You see which characters you can enter
with that key. Each time the key is pressed,
the next character is selected.
Example: key l:
R
press once = A
R
press twice = B
R
press three times = C
X
Wait until the character display goes out.
The
entries matching your input are shown
in the list.
X
Enter E, R, L, I, N using the corresponding
keys.
Further functions in the list with char-
acter bar
X
To delete characters: press
the $ but-
ton on the control panel.
or
X
Press the j button next to the
COMAND controller.
or
X
Select the F symbol in the character bar
by sliding VÆ and turning cVd the
COMAND controller and press W to con-
firm.
X
To delete an entry: press $ on the
control panel.
or
X
Press and hold the j
button next to the
COMAND controller until the entire entry is
deleted.
or
X
Select the F symbol in the character bar
and press and hold W the COMAND con-
troller until the entire entry is deleted.
X
To switch the character set: select
B and press W to confirm.
This
will switch the character set from Latin
to Cyrillic and back.
372
At a glance
COMAND Online