User's Manual

Table Of Contents
36 Telephone
Via the speller
Applies to vehicles: with phone pr
e-installation
Fig. 27 Entering a telephone number via the speller
for numbers
Fig. 28
Entering a telephone number via the speller
for letters
Select:
TEL
button > Enter number.
T
o enter a telephone number using num-
bers: Enter a telephone number using the
speller for numbers ð Fig. 27.
To enter a telephone number using letters:
Press the control button for A-Z. Enter a ser-
ies of letters, e.g. AUDISERVICE using the
speller for letters.
To dial a telephone number: Select and con-
firm OK. Or: Press the control button for Di-
al. The current audio source is muted while
the connection is established.
If you have entered incorrect digits, select and
confirm . You can delete all characters en-
tered at once by turning the speller to and
pressing and holding the rotary pushbutton.
Note
You can enter D
TMF tones ("touch-tones")
using the speller while you are talking on
the phone.
Listening to voice mail messages
Applies to vehicles: with phone pr
e-installation
Select:
TEL
button > control button Mail-
bo
x.
To enter the mailbox number: Select and
confirm List and select and confirm the de-
sired number. Or: Enter the mailbox number
using the speller. Select and confirm OK.
To dial the mailbox number: Press the con-
trol button for Mailbox.
Note
This ser
vice must be set up and activated
on your mobile network before you can
use it. For more information, contact
your service provider.
The mailbox number depends on your
service provider.
Answering/ignoring
telephone cal
ls
Applies to vehicles: with phone pre-installation
Fig. 29 Incoming call
Important: There must be an incoming call,
an active call
, or the phone must be establish-
ing a connection.
To answer a call: Press the control button
for Answer.
To ignore a call: Press the control button for
Ignore.
To end a call/cancel the dialling process:
Press the control button for End call.
To answer a further call: If you are already
talking on the phone when someone else
calls, select Answer to place the current call
2
Titel oder Name, Abteilung, Datum