User's Manual Part 3

Working with Automated Systems

This method is designed to be used in instances where one gen-

erally has to press numbers on the cellular phone keypad while

navigating through an automated telephony system.

You can use your UConnect™ system to access a voicemail

system or an automated service, such as, paging service or

automated customer service. Some services require immediate

response selection, in some instances, that may be too quick for

use of UConnect™ system.

When calling a number with your UConnect™ system that nor-

mally requires you to enter in a touch-tone sequence on your

cellular phone keypad, you can push the VR hard-key and say

the sequence you wish to enter followed by the word “Send.”

For example, if required to enter your pin number followed with a

pound 3 7 4 6 #

1. Press the VR button

2. Say 3 7 4 6 # SEND

Saying a number, or sequence of numbers, followed by SEND is

also to be used to navigate through an automated customer

service center menu structure and to leave a number on a pager.

Turning Conﬁrmation Prompts On/Off

Turning conﬁrmation prompts off will stop the system from con-

ﬁrming your choices (e.g. the UConnect™ system will not repeat

a phone number before you dial it).

1. Press the UConnect™ hard-key to begin.

2. Wait for the beep.

3. Say UCONNECT SETUP.

4. After the “Ready” prompt and the following beep, say CON-

FIRMATION PROMPTS.

5. The UConnect™ system will play the current conﬁrmation

prompt status and you will be given the choice to change it.

Phone and Network Status Indicators

If available on the radio and/or on a premium display such as the

instrument panel cluster, and supported by your cell phone, the

UConnect™ system will provide notiﬁcation to inform you of your

phone and network status when you are attempting to make a

phone call using UConnect™. The status is given for roaming,

network signal strength, phone battery strength, etc.

SPEECH DIALOGUE SYSTEM