User's Manual Part 3

The navigation radio transfers the call immediately, and you can
continue your call on the cellphone.
Automatic Transfer Call to UConnect™ System
If you have an ongoing call on a cellphone which was paired with
the UConnect System before, and the navigation radio is off, turn
on the ignition and allow the UConnect system to automatically
transfer the call. This may take a few seconds.
List All Paired Cellular Phone Names
1. Press the UConnect™ hard-key to begin.
2. Wait for the beep.
3. Say UCONNECT SETUP.
4. After the following beep, say PHONE PAIRING.
5. After the following beep, say LIST PAIRED PHONES.
6. The UConnect™ system will play the phone names of all
paired cellular phones in order from the highest to the lowest
priority.
To “select” or “delete” a paired phone being announced, press
the VR hard-key and say SELECT or DELETE. Also, see next
two sections for alternate way of doing this.
Select another Cellular Phone
You may select phones via touch screen in the Paired Devices
menu. (Refer to the Getting Started section in this manual for
more details).
This feature allows you to select and start using another phone
with the UConnect™ system.
The phone must have been previously paired to the UConnect™
system that you want to use it with.
1. Press the UConnect™ hard-key to begin.
2. Wait for the beep.
3. Say UCONNECT SETUP.
4. After the following beep, say SELECT PHONE.
The phone names along with priority numbers will be announced.
5. When prompted say the priority number of the cellular phone
you wish to select.
6. You can also press the VR hard-key anytime while the list is
being played.
7. Say the priority number choose select of the phone that you
wish to select.
The selected phone will be used for the next phone call. If the
selected phone is not available, the UConnect™ system will
SPEECH DIALOGUE SYSTEM
93