User's Manual

To activate the UConnect™ system from idle, simply press the
UConnect™ button and follow audible prompts for direc-
tions. All UConnect™ system sessions begin with a press of the
UConnect™ button .
Cancel Command
At any prompt, after the beep, you can say “Cancel” and you will
be returned to the main menu. However, in a few instances the
system will take you back to the previous menu.
Pair (Link) to a Cellular Phone
To begin using your UConnect™ system, you must pair your
compatible Bluetooth™ enabled cellular phone (refer to “Intro-
duction” section to learn about the phone type). To complete the
pairing process, you will need to reference your cellular phone
owner’s manual. One of the following vehicle specific websites
may also provide detailed instructions for pairing with the brand
of phone that you have:
www.chrysler.com/uconnect or www.dodge.com/uconnect or
www.jeep.com/uconnect
Phone pairing can either be done using the setup menu (see
Getting Started section in this manual) or using voice commands.
Pairing will walk you through a series of steps that will establish a
connection between your handset and the UConnect™ system in
the vehicle.
Once set up, you do not need to re- pair your phone with each
use. However, every new phone must be paired before it can be
used.
The following are general phone to UConnect™ System voice
pairing instructions:
1. Press the UConnect™ button to begin.
2. Wait for the beep.
3. Say PHONE PAIRING.
4. When prompted, after the beep, say PAIR A PHONE and fol-
low the audible prompts.
5. You will be asked to say a four-digit pin number which you will
later need to enter into your cellular. You can enter any four-digit
pin number. You will not need to remember this pin number after
the initial pairing process.
SPEECH DIALOGUE SYSTEM
100