User's Manual

Power to operate the navigation radio is supplied through the

ignition switch, which must be in the ON, ACC or in ACC Delay

mode in order to operate the navigation radio.

It is also possible to set the unit in standby mode during driving,

by pressing the ON/OFF VOLUME rotary knob.

Turn the ON/OFF VOLUME rotary knob to adjust the volume.

Turn the ON/OFF VOLUME rotary knob while the navigation

voice is speaking to adjust the volume of the navigation voice.

Note: If the ignition is switched off with the radio in standby mode, the

radio memorizes the standby state when the ignition is switched on again.

Press the ON/OFF VOLUME rotary knob to switch the radio on. The navi-

gation software is always working when the ignition is switched on, even if

the radio is in standby mode. It is possible to eject the CD and to display

the time if the unit is switched off. It may take a few seconds for the radio

to power up and show the time or the changer screen.

(15) RADIO

Press the RADIO button to toggle between RADIO modes AM,

FM, SAT, SATV (if equipped).

(16) MEDIA

Press the MEDIA button to toggle between MEDIA modes HDD,

DISC, AUX, VES (if equipped).

(17) NAV

Press the NAV button either to switch to the navigation mode or

to toggle between the navigation menu and the map viewer

screen.

(18) VR

Press the VR button and wait for the conﬁrmation beep be-

fore you say a voice command.

(19) BACK

Press the BACK button to get to the previous screen.

GENERAL HANDLING