User's Manual

Uconnect™ ACCESS USER’S MANUAL 175
Touching the trks soft -key while the pop up is displayed Controlling the Auxiliary Device
will close the pop up.
Audio
Refer to Radio Mode for adjusting the audio settings.
OPERATING INSTRUCTIONS – AUX MODE
Overview
AUX Mode is ente red by inserting an AUX device using
a cable with a 3.5 mm audio jack into the AUX port or
touch the AUX soft-key on the left side of the display.
Once in Media Mode, touch the sou rce soft -key and select
AUX.
Inserting Auxiliary Device
Gently insert the Auxiliary device cable into the AUX
Port. If you insert an Auxiliary device with the ignition
ON and the radio ON, the unit will switch to AUX mode
and begin to play when you insert the device cable.
The control of the auxiliary device (e.g., selecting play-
1
lists, play, fast forwa rd, etc.) cannot be provided by the
radio; use the device cont rols instead. Adjust the volume
with the ON/OFF VOLUME rotary knob, or with the
volume of the attached device.
NOTE: The vehicle radio unit is acting as the amplifier
for audio output from the Auxiliary device. The refo re if
the volume cont rol on the Auxiliary device is set too low,
the re will be insu fficient audio signal for the radio unit to
play the music on the device.
Source
Touch the Source soft-key to select the desired audio
source, Disc, USB/iPod ® , SD Card, AUX or Bluetooth ® .
This screen will time out after a few seconds and return
to the main radio screen if no selection is made.
Audio