User's Manual Part 2

260
Care of the vehicle
Never fit tyres of uncertain origin.
Warning
The tyres are of the “directional” type and there is an arrow
marked on their side wall to indicate the direction in which
they must rotate or which side is the outer side. When replaced,
maximum performance levels can only be ensured if the rotation
direction corresponds with the direction indicated by the arrow.
Tyres on the same axle must always be replaced in pairs.
Regularly check the tyre tread (minimum acceptable depth
1.7 mm). As the tread wear increases, there is a greater risk of
skidding.
Warning
Drive carefully on wet roads to reduce the risk of “aquaplaning”.
Wheel alignment check and adjustment
When you notice unusual wear of the tyres and in any case, at the
intervals prescribed in the “Warranty Booklet”, have the Ferrari
Service Network check the wheel toe-in and camber.
Maintenance of seat belts and pretensioners
s0ERIODICALLYCHECKTHATTHESCREWSONTHEANCHORPOINTSARETIGHT
and that the seat belt is in perfect condition and slides smoothly
.
s4HESEATBELTMUSTBEKEPTCLEANTHEPRESENCEOFANYDIRTCOULD
prevent the seat belt retractor from working properly.
s
4OCLEANTHESEATBELTWASHITBYHANDWITHMILDSOAPANDWATER
rinse it and let it dry. Do not use strong detergents, bleach or
aggressive solvents, as they can weaken the fibres.
s$ONOTLETTHESEATBELTRETRACTORSGETWETPROPERFUNCTIONINGIS
only ensured if they are kept dry.
s
4HE
PRETENSIONERREQUIRESNOMAINTENANCEORLUBRICATION)F
immersed in water or mud, the pretensioner must necessarily be
replaced.
s4HEPRETENSIONERMUSTBEREPLACEDATTHEINTERVALSINDICATEDIN
the “Warranty Booklet”.