User Manual Part 6

2. Select the Bluetooth phone/device to be connected or
disconnected.
● “Connected (Connected)” is displayed next to the
currently connected Bluetooth phone/device.
● If the desired Bluetooth phone/device is not on the
list, select
(Add Device) to register the
Bluetooth phone/device. (→P.48)
3. Select (Connect) or
(Disconnect).
4. Check that “Connected (Connected)” is displayed next
to the Bluetooth phone/device when the connection is
complete.
● If an error message appears, follow the guidance on
the screen to try again.
NOTE
l It may take time if the Bluetooth phone/device connection is
carried out during Bluetooth audio playback.
l Depending on the type of Bluetooth phone/device being
connected, it may be necessary to perform additional steps on
the Bluetooth phone/device.
AUTO CONNECTION MODE
Leave the Bluetooth phone/device in a location where the
connection can be established.
● When the ignition switch is in the “ACC” or “ON”
position, the system searches for a nearby registered
Bluetooth phone/device.
● The system will connect with the registered Bluetooth
phone/device that was last connected, if it is nearby.
Bluetooth
®
SETTINGS
50