Stereo Receiver User Manual

AVR
21
ENGLISH
Making Connections
Install a Multizone System
IMPORTANT  SAFETY  NOTE:  Installing  a  multizone  system  typically  requires 
running cables inside walls. Always comply with the appropriate safety codes 
when installing  concealed wiring, particularly all applicable building codes. 
Failure to do so may present a safety hazard. If you have any doubt about your 
ability  to  work  with  electrical wiring,  hire  a licensed  electrician  or  custom 
installer to install the multizone system.
NOTE: Only the following analog audio sources are available to Zone 2: the internal radio 
(FM, AM and SIRIUS, if connected – AVR 3650/AVR 2650 only), an iPod/iPhone device 
docked in a connected The Bridge IIIP, a USB memory device inserted in the AVR’s USB 
port (AVR 3650/AVR 365 only) and up to three source devices connected to the rear-panel 
Analog Audio 1, 2 and 3 connectors.
Your AVR offers two different methods of distributing audio to other areas in your home. 
Each requires different connections:
A.  Connect  the  Zone  2  speakers  directly  to  the  Assigned  Amp  Speaker  Output 
connectors. Assign  the  Assigned Amp  channels  to  power  the  Zone  2  speakers  (see 
Manual Speaker Setup
, on page 36). This method allows you to power a single pair of 
speakers for Zone 2.
This method offers the benefit of reduced cost and complexity, but your home theater 
system will be limited to 5.1 channels – the AVR will automatically downmix the playback 
of programs recorded in 6.1 or 7.1 channels to 5.1 channels.
Zone 2 
Speakers
Assigned 
Amp 
Speaker 
Connectors
5.1-Channel 
Home Theater 
Speaker System
AVR
Speaker Wire 
(not supplied)
Speaker Wire 
(not supplied)
Zone 2
Main Room
FL
SL SR
FR LFE
C
Connect a SIRIUSConnect Radio Tuner (AVR 3650 and AVR 2650 only)
Connect  the  multi-pin  DIN  cable  supplied  with  the  SIRIUSConnect  tuner  to  the  AVR’s 
SIRIUS Tuner connector and to the corresponding connector on the SIRIUS module. The 
AVR will supply power to the SIRIUS module so you will not need to connect the power 
supply included with the module. You will need to purchase a SIRIUS radio subscription 
and activate the tuner module, following the instructions included with the SIRIUS module 
and from the SIRIUS Web site at www.sirius.com.
AVR 
SIRIUS Tuner 
Connector
Eight-Pin DIN Cable 
(supplied with SIRIUS tuner)
SIRIUSConnect Tuner
0295CSK - HK (x65Series) AVR3650_365_2650_265 CORE OM, WORK18 danny.indd 21 01/07/11 11:33:48










