•AVR40 Cover (j).qx 9/15/98 3:38 PM Page 2 Harman Kardon AVR40 Audio/VideoReceiver Volume Contour STEREO TUNED AUTO TAPE M Ref PRESET KHz MHz ms y 1 AM / FM 2 3 CD Tape 1 4 5 Tape 2 SLEEP HALL Pro Logic 6 TV 7 Video 1 8 Video 2 Wrap 9 0 Surround Bass Video 3 Ctr.
•AVR40 Cover (j).qx 9/15/98 3:38 PM Page 3 Owner’s Manual AVR40 Audio/Video Receiver Table of Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Safety Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3 Unpacking and Installation . . . . . . . . . . . . . . . . 3 Conventions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Front Panel Controls . . . . . . . . .
•AVR40 Cover (j).qx 9/15/98 3:38 PM Staple or clip original invoice here.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 1 Introduction 1 Congratulations! With the purchase of a Harman Kardon AVR40 you are about to begin many years of listening enjoyment. The AVR40 has been custom designed to provide all the excitement and detail of movie soundtracks and every subtle nuance of musical selections. take a few minutes to read through this manual. This will ensure that connections to speakers, source playback units and other external devices are made properly.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 2 Safety Information 2 Important Safety Information Verify Line Voltage Before Use Your AVR40 has been designed for use in North America with 120 volt AC current. Connection to a line voltage other than that for which it is intended can create a safety and fire hazard, and may damage the amplifier.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 3 Safety Information 3 Cleaning When the unit gets dirty, wipe it with a clean, soft dry cloth. If necessary, wipe it with a soft cloth dampened with mild soapy water, then a fresh cloth with clean water. Wipe dry immediately with a dry cloth. NEVER use benzene, thinner, alcohol or any other volatile cleaning agent. Do not use abrasive cleaners, as they may damage the finish of metal parts. Avoid spraying insecticide near the unit.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 4 Front Panel Controls 4 ¸ ˘ ¯ ˜ ˆ ı Ù Volume Contour STEREO . P Scan TUNED AUTO TAPE M Tuning Mode Ref PRESET KHz MHz ms Center Rear Delay Video 1 Video 3 SLEEP HALL Pro Logic Video 2 Wrap Video 1 Calibrate Memory 1 2 3 CD Tape 1 4 5 6 7 8 9 0 Surround Ctr.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 5 Front Panel Controls 5 1 Main Power Switch: Press this button to apply power to the AVR40. When the switch is pressed the unit is placed in a Standby mode, as indicated by the amber LED 3 surrounding the System Power control 2. This button MUST be pressed in to operate the unit regardless of the status of the Power Switch at the bottom of the front panel.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 6 Front Panel Controls 6 Ó Tuner Memory Button: Press this button to store an AM or FM frequency in the unit’s memory. The MEM indicator will flash in the display to remind you to choose a numeric location using Numeric Buttons Ô on the front panel. Storing a station in a memory location that has already been used will overwrite the existing data. Ô Numeric Buttons: Use these buttons to enter or recall stations from the tuner memory.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 7 Rear Panel Connections 7 b · d ce a ° g f ‡ IN ANTENNA RIGHT AM LOOP AC INPUT AC 120V/60HZ 2A LEFT CENTER PRE OUT OUT MADE IN KOREA REMOTE CONTROL REAR PRE OUT AC OUTLETS MAIN IN VIDEO FRONT VIDEO 2 FM 75Ω VIDEO 1 SUB WOOFER OUT CD LEFT IN TV TAPE 2 TAPE 1 MON VIDEO 2 IN OUT SWITCHED TOTAL 1A MAX 100W AC 120V/60Hz CENTER SPEAKER 8Ω MONITOR PRE OUT OUT FRONT SPEAKERS 8Ω VIDEO 1 MODEL NO.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 8 Rear Panel Connections 8 ¡ CD Input: Connect the output of your CD player or D/A converter to these jacks. ™ TV Input: Connect the audio outputs of a TV, satellite receiver or any audio source to these jacks. £ Tape 2 Input: Connect the PLAY/OUT jacks of an audio tape recorder to these jacks. ¢ Tape 2 Output: Connect the RECORD/INPUT jacks of an audio tape recorder to these jacks.
•AVR40 om (j).
•AVR40 om (j).qx 9/15/98 3:47 PM Page 10 Remote Control Functions 10 a Infrared Transmitters: An infrared beam is transmitted from these emitters when you press any button on the remote. For best operation, always point the front of the remote towards the sensor on the AVR40 35 and do not obstruct this area. b Sleep: Press this button to place the unit in the sleep mode. The display will dim and the unit will turn off after the number of minutes shown in the information display.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 11 Installation and Configuration 11 Your new Harman Kardon receiver is designed to provide the best reproduction from both movies and musical programs. To assure that the unit operates to its fullest capability, it is important that you spend a few minutes to properly install and configure all of the elements in your new system. Some, or all of the following steps will apply to your system, depending on the equipment in use.
•AVR40 om (j).
•AVR40 om (j).qx 9/15/98 3:47 PM Page 13 Installation and Configuration 13 Consult the subwoofer instructions or consult your dealer for additional information. When using a single subwoofer and a separate mono power amplifier, the AVR40 subwoofer outputs must be combined using an optional “Y” adapter. If there is no crossover in the subwoofer an optional, external low pass filter or crossover system must be used.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 14 Installation and Configuration 14 NOTE: The Balance control $ should be at the midpoint, or “12 O’clock” position when calibrating the system. Press the Calibrate button q on the remote again and note that a test tone will be heard from the left front speaker. Press the Speaker › button s and observe that the test noise will move first to the center speaker, then to the front right speaker and then to the rear speakers as you press the button.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 15 Operation 15 Once you have completed the setup and installation of your new receiver, it is simple to operate and enjoy. The following instructions will provide the steps needed to enjoy the advanced features of the AVR40 • When using the AVR40 for the first time, it is necessary to press the Main Power Switch 1 on the front panel to turn the unit on.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 16 Operation 16 Surround Mode Options The AVR40 offers a choice of surround modes. To select a surround mode press the Surround button r on the front panel or remote. The choice of which surround mode to use is influenced by the type of program material being played and the specifics of your listening room setup.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 17 Operation 17 To some ears the impact of the wrap circuit may seem subtle, and this is normal. Remember that how audible the wrap effect will be varies with the acoustics of your listening room, the output settings established during the calibration process, the system volume and the type of program material in use.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 18 Operation 18 Preset Tuning Up to 30 stations may be stored in the AVR40’s memory for easy recall using the front panel controls or the remote. To enter a station to the memory, first tune the station using the steps outlined above. Then: 1. Press the Memory button Ó on the front panel. Note that the MEM indicator will illuminate and flash in the information display. 2.
•AVR40 om (j).qx 9/15/98 3:47 PM Page 19 Troubleshooting 19 This unit is designed for trouble-free operation. Most problems users encounter are due to operating errors. So, if you have a problem, first check this list for a possible solution. If the problem persists, consult your authorized Harman Kardon Service Center. If the problem is... Make sure that the...
•AVR40 om (j).qx 9/15/98 3:47 PM Page 20 Technical Specifications 20 Stereo Mode Continuous Average Power (FTC) 65 Watts from 20Hz-20kHz: Tuner Section: FM @<0.09% THD both channels driven into 8 ohms Five Channel Surround Mode Continuous average power per channel (FTC) Front L&R channels: 55 Watts from 20Hz-20kHz @<0.3% THD both channels driven into 8 ohms Center channel: 55 Watts at 1kHz @<0.3% THD driven into 8 ohms Rear channels: 2 x 25 Watts at 1kHz: @<0.
•AVR40 Cover (j).qx 9/15/98 3:38 PM Page 1 STEREO . P Scan TUNED AUTO TAPE M Tuning Mode Ref PRESET KHz MHz ms Center Power Headpnone Rear Delay Video 1 Video 3 AVR40 rev (j) 4/16/97 Wrap Video 1 Calibrate Memory Speaker 1 AM / FM 2 3 CD Tape 1 Monitor Printed in Korea SLEEP HALL Pro Logic Video 2 Part #1111-AVR 40 9007018730 4 5 Tape 2 6 TV 7 Video 1 8 Video 2 9 Video 3 0 Surround Bass Ctr.
