The Bridge III DOCKING STATION FOR iPod and iPhone OWNER’S MANUAL 1 0126CSK - HK Bridge lll All v7.
InTRODUCTIOn Congratulations! With The Bridge III, you are entering the new world of entertainment made possible by combining the incredible storage capacity and playback flexibility of an iPod or iPhone with the sonic power of your Harman Kardon® system.
InSTALLATIOn English InstallIng With only a single cable connection, The Bridge III is easy to connect to your Harman Kardon product. step One: Turn off the Harman Kardon The Bridge III-ready product, using its main power switch. step Five step Four step two: Holding the cable with the wider part of the connector at the bottom, gently squeeze the tabs on each side as you insert it into the connector on the rear panel of the Harman Kardon product. See Figure 1. Figure 1 – The Bridge III connector.
OPERATION USING DOCKING STATION When The Bridge IIIs connected to its proprietary input on the AVR and the iPod or iPhone is docked, you may play the audio, video and still-image materials on your iPod or iPhone through your high-quality audio/video system; operate the iPod or iPhone using the AVR remote or the AVR’s front-panel controls; view navigation messages on the AVR’s front panel or a connected video display; and charge the iPod or iPhone.
NOTES ON VIDEO PLAYBACK: • As of this writing, video browsing is only supported on the iPod 5G, iPod classic (80GB,120GB and 160GB), iPod nano 3G and 4G, and iPod touch or iPhone (when loaded with software version 2 or higher). For other iPod models, it is not possible to view photos (except iPod 4G) or videos on an external monitor while using The Bridge III.
OPERATION Table 5 – Using The Bridge III in iPod Manual Mode Charging the iPod or iPhone You may leave your iPod or iPhone in The Bridge III even when you are not using it as a playback source. Whenever the iPod or iPhone is docked and your receiver is turned on, The Bridge III will charge the battery in the iPod or iPhone.
SYMPTOM SOLUTION The iPod or iPhone does not play or respond to commands from the receiver’s remote. • Make sure that The Bridge III is properly connected to a compatible Harman Kardon receiver. English TROUBLESHOOTING • Make sure that The Bridge is selected as the input on the receiver. Specifications: Dimensions (H x W x D): 1-3/16” x 4-1/2” x 4-1/2” (30mm x 114mm 114mm) Weight: 0.37 lb (0.17kg) © 2009 Harman International Industries, Incorporated. All rights reserved.
250 Crossways Park Drive, Woodbury, New York 11797 www.harmankardon.com © 2009 Harman International Industries, Incorporated. All rights reserved. Part No. 950-0273-001 8 0126CSK - HK Bridge lll All v7.