HK 3385 OM 4/13/07 12:02 PM Page 1 HK 3385 STEREO RECEIVER OWNER’S MANUAL
HK 3385 OM 4/13/07 12:02 PM Page 2 SAFETY INFORMATION 1. Read Instructions. All the safety and operating instructions should be read before the product is operated. 2. Retain Instructions. The safety and operating instructions should be retained for future reference. 3. Heed Warnings. All warnings on the product and in the operating instructions should be adhered to. 4. Follow Instructions. All operating and use instructions should be followed. 5. Cleaning.
HK 3385 OM 4/13/07 12:02 PM Page 3 SAFETY INFORMATION Important Safety Information Verify Line Voltage Before Use Your HK 3385 has been designed for use with 120-volt AC current. Connection to a line voltage other than that for which it is intended can create a safety and fire hazard and may damage the unit. If you have any questions about the voltage requirements for your specific model, or about the line voltage in your area, contact your selling dealer before plugging the unit into a wall outlet.
HK 3385 OM 4/13/07 12:02 PM NOTES 4 Page 4
HK 3385 OM 4/13/07 12:02 PM Page 5 TABLE OF CONTENTS 2 6 7 9 10 12 14 14 14 14 14 15 15 16 17 17 17 17 17 19 19 20 20 20 20 21 21 21 21 21 21 22 22 22 22 23 24 24 24 25 26 26 27 SAFETY INFORMATION INTRODUCTION FRONT-PANEL CONTROLS FRONT-PANEL INFORMATION DISPLAY REAR-PANEL CONNECTIONS REMOTE CONTROL FUNCTIONS CONNECTIONS Speaker Connections Subwoofer Connecting Source Devices to the HK 3385 Analog Audio Connections Video Connections Antennas SPEAKER PLACEMENT INSTALLATION Step One – Connect the Speaker
HK 3385 OM 4/13/07 12:02 PM Page 6 INTRODUCTION Please register your product on our Web site at www.harmankardon.com. Note: You’ll need the product’s serial number. At the same time, you can choose to be notified about our new products and/or special promotions. WWW.HARMANKARDON.
HK 3385 OM 4/13/07 12:02 PM Page 7 FRONT-PANEL CONTROLS Power Switch: This electrical switch turns the receiver on for playback, or leaves it in Standby mode for quick turn-on using the remote control. Treble Control: Turn the knob clockwise to boost high-frequency Power Indicator: This LED has two modes. When power is turned off, the LED is amber to indicate that the receiver is plugged in and ready to be turned on. When the receiver is turned on, the LED turns blue.
Headphone Jack Speaker 1/2 Preset Scan Preset Stations Tuner Band FM Mode Bass Control Video 3 Video Input Video 3 Audio Inputs Balance Control NOTE: To make it easier to follow the instructions throughout the manual that refer to this illustration, a copy of this page may be downloaded from the Product Support section at www.harmankardon.com.
HK 3385 OM 4/13/07 12:02 PM Page 9 FRONT-PANEL INFORMATION DISPLAY SPEAKER 1 Mute Auto Tuned Stereo Memory Preset Sleep MUTE AUTO TUNED STEREO MEMORY SPEAKER 2 Speaker 1/2 Messages PRESET SLEEP Preset Number/ Sleep Timer PHONO FM AM CD VID 1 VID 2 VID 3 TAPE M. Source Inputs NOTE: To make it easier to follow the instructions that refer to this illustration, a larger copy may be downloaded from the Product Support section for this product at www.harmankardon.com.
HK 3385 OM 4/13/07 12:02 PM Page 10 REAR-PANEL CONNECTIONS AM and FM Antenna Terminals: Connect the included AM and FM antennas to their respective terminals for radio reception. Video 1, Video 2 and Video 3 Audio/Video Inputs: These jacks may be used to connect your video-capable source components (e.g., VCR, DVD player, cable TV box) to the receiver. NOTE: The Video 3 source has inputs on both the front and rear panels of the HK 3385, and you may connect different devices to each set of inputs.
Preamp Outputs Subwoofer Outputs Main-Amp Inputs Remote IR Input Remote IR Output Speaker 1 Outputs Speaker 2 Outputs Switched AC Accessory Outlets AC Power Cord NOTE: To make it easier to follow the instructions throughout the manual that refer to this illustration, a copy of this page may be downloaded from the Product Support section at www.harmankardon.
HK 3385 OM 4/13/07 12:02 PM Page 12 REMOTE CONTROL FUNCTIONS The HK 3385 remote is capable of controlling six devices, including the HK 3385 itself. The remote is preprogrammed at the factory to operate most Harman Kardon DVD, CD and CDR players. Each time you wish to use the codes for any component, you will need to first press the Selector Button for that component. This changes the button functions to the appropriate codes for that product.
HK 3385 OM 4/13/07 12:02 PM Page 13 REMOTE CONTROL FUNCTIONS Auto Preset: The Auto Preset feature enables you to automatically set presets for all available FM radio stations in your area with a single button press. To start the process, make sure the FM tuner has been selected as the source. Press and hold this button. The Memory and Preset Indicators will flash as the HK 3385 tuner scans through all FM stations with acceptable signal quality and programs them into the presets.
HK 3385 OM 4/13/07 12:02 PM Page 14 CONNECTIONS There are different types of audio and video connections used to connect the receiver to the speakers and video display, and to connect the source devices to the receiver. To make it easier to keep them all straight, the Consumer Electronics Association (CEA®) has established a color-coding standard. Table 1 may be helpful to you as a reference while you set up your system.
HK 3385 OM 4/13/07 12:02 PM Page 15 CONNECTIONS Video Connections Although some sources produce an audio signal only (e.g., CD player, tape deck), many sources output both audio and video signals (e.g., DVD player, cable television box, HDTV tuner, satellite box, VCR, DVR). In addition to the audio connection, you will need to make a video connection for each source. Composite video is the basic connection most commonly available, and is the only type of video connection available with the HK 3385.
HK 3385 OM 4/13/07 12:02 PM Page 16 SPEAKER PLACEMENT Before you begin to connect cables, it is important to set up your speakers in their correct locations in the room. Optimally, the front left and right speakers are placed the same distance from each other as from the listening position, or about 60 degrees apart, and angled toward the listener. The subwoofer’s location is less critical, since low-frequency sounds are omnidirectional.
HK 3385 OM 4/13/07 12:02 PM Page 17 INSTALLATION You are now ready to connect your various components to your receiver. Before beginning, make sure that all components, including the HK 3385, are turned completely off and their power cords are unplugged. Don’t plug any of the power cords back in until you have finished making all of your connections. Remember that your receiver generates heat while it is on. Select a location that leaves several inches of space on all sides of the receiver.
HK 3385 OM 4/13/07 12:03 PM Page 18 INSTALLATION Table 2 – Remote Control Device Types Source Input Remote Control Device Type Phono Operates HK 3385 only Video 1 Harman Kardon DVD player Video 2 Harman Kardon DVD player Video 3 Harman Kardon DVD player Tape/CDR Harman Kardon CD recorder CD Harman Kardon CD player AM/FM Operates HK 3385 only Compact Disc (CD) Player Connect the analog audio outputs of your CD player (or another audioonly device) to the CD Audio Inputs. See Figure 13.
HK 3385 OM 4/13/07 12:03 PM Page 19 INSTALLATION Video 2 Source The Video 2 source is used only for playback. Since the remote is preprogrammed to operate a Harman Kardon DVD player when the Video 2 source is selected, we recommend that you connect a DVD player to the Video 2 Inputs. You may have observed that the HK 3385 is not equipped with digital audio inputs or surround sound decoding.
HK 3385 OM 4/13/07 12:03 PM Page 20 INSTALLATION connect the HK 3385’s Remote IR Output to the source device’s Remote IR Input, which will pass any applicable remote signals transmitted through the HK 3385 to the source device. This enables you to control your sources even when the HK 3385 itself is controlled via an external IR receiver. You may plug two devices into the AC Switched Accessory Outlets on the rear of the HK 3385. See Figure 21. Make sure each device draws no more than 100 watts.
HK 3385 OM 4/13/07 12:03 PM Page 21 OPERATION Now that you have installed your system components, you are ready to begin enjoying your new audio system. Turning On the HK 3385 After you plug the power cord into an AC outlet, the Power Indicator should light up in amber. This indicates that the HK 3385 is in Standby mode and is ready to be turned on. See Figure 23. The HK 3385 may be turned on by pressing the Power Switch on the front panel or the remote. See Figure 24.
HK 3385 OM 4/13/07 12:03 PM Page 22 OPERATION Figure 30 – Balance Control The Balance Control reduces the level of the speaker opposite the pointer. For example, turning the knob from the midpoint toward “R” reduces the level of the left speaker, leaving the right speaker unaffected. If two pairs of speakers are connected to the HK 3385, then both will be affected. Headphones Plug the 1/4" plug on a pair of headphones into the headphone jack on the front of the receiver for private listening.
HK 3385 OM 4/13/07 12:03 PM Page 23 OPERATION To store a station in one of the 30 presets (see Figure 35): 1. Tune the desired station. 2. Press the Memory Button on the remote. 3. Use the Numeric Keys to enter the desired preset number. To clear a station from the preset memory: 1. Tune the preset station using any of the methods described above. 2. Press the Memory Button. 3. Within five seconds, press the Clear Button.
HK 3385 OM 4/13/07 12:03 PM Page 24 OPERATION Dim Function Some people find the front-panel messages distracting and would prefer to dim them or turn them off altogether. To dim the display, press the Dim Button on the front panel or remote.
HK 3385 OM 4/13/07 12:03 PM Page 25 TROUBLESHOOTING GUIDE SYMPTOM CAUSE SOLUTION Unit does not function when Main Power Switch is pushed • No AC power • Make certain AC power cord is plugged into a live outlet • Check to see whether outlet is switch-controlled Display lights, but there’s no sound or picture • Intermittent input connections • Make certain that all input and speaker connections are secure • Mute is on • Press Mute Button • Volume Control is down • Turn up Volume Control • Desired
HK 3385 TECHNICAL SPECIFICATIONS Audio Section Stereo Mode: Continuous Average Power (FTC): 80 Watts per channel, 20Hz – 20kHz, @ <0.07% THD, both channels driven into 8 ohms 100 Watts per channel, 20Hz – 20kHz @ <0.
HK 3385 OM 4/13/07 12:03 PM Page 27 APPENDIX Remote Control Function List Button Phono Controls HK 3385 Only VID 1 DVD Player Control Codes VID 2 DVD Player Control Codes VID 3/VID Front DVD Player Control Codes Tape MON/CDR CD Recorder Control Codes CD CD Player/Changer Control Codes AM Controls HK 3385 Tuner Only FM Controls HK 3385 Tuner Only Main Power On Main Power Off Speakers 1 Speakers 2 Phono Tape/CDR VID 1 VID 2 VID 3 CD AM FM Preset Down I << Preset Up >>I Tuning Down << Tuning Up >>
HK 3385 OM 4/13/07 12:03 PM Page 28 250 Crossways Park Drive, Woodbury, New York 11797 www.harmankardon.com © 2007 Harman International Industries, Incorporated. All rights reserved. Part No.
