CITATION SUB OWNER’S MANUAL
/ IMPORTANT SAFETY INSTRUCTIONS Verify Line Voltage Before Use The Citation subwoofer has been designed for use with 100240 volt, 50/60 Hz AC current. Connection to a line voltage other than that for which your product is intended can create a safety and fire hazard and may damage the unit. If you have any questions about the voltage requirements for your specific model or about the line voltage in your area, contact your selling dealer before plugging the unit into a wall outlet.
/ TABLE OF CONTENTS /IMPORTANT SAFETY INSTRUCTIONS.............................................. 2 /INTRODUCTION ........................................................................................ 4 /WHAT’S IN THE BOX................................................................................ 5 /PRODUCT OVERVIEW............................................................................. 6 /GET STARTED.............................................................................................
/ INTRODUCTION This manual includes information of CITATION SUB (subwoofer). We encourage you to take a few minutes to read this manual, which describes the products and includes step-by-step instructions to help you set up and get started. Read and understand all the safety instructions before using your product. Design and specifications are subject to change without notice.
/ WHAT’S IN THE BOX Carefully unpack the box and check if the following parts are included. If any part is damaged, do not use it, contact your Harman Kardon retailer or customer service. 1 2 1. Main unit 2. Power cord* *Power cord quantity and plug type vary by regions.
/ PRODUCT OVERVIEW Back Panel 1 2 3 4 1. SERVICE • For service only. 2. RESET • Press and hold for 5 seconds to reset your subwoofer. 3. LED indicator 4. POWER • Connect to the power supply.
/ PRODUCT OVERVIEW LED Indicator White (Flashing) Enter into pairing mode White (Flashing) Out of range / Lost wireless connection White (Constant for 10 seconds and then light off) Wirelessly connected with CITATION BAR / ADAPT / TOWER) 7
/ GET STARTED Placement Place your CITATION SUB (subwoofer) on any flat and stable surface near an AC (mains) outlet. For a successful connection, keep a maximum distance of 5 meters (16.4 feet) between the CITATION SUB and your CITATION BAR / ADAPT / TOWER. Power on your CITATION SUB NOTES: • • Use the provided power cord only. When you disconnect the power cord, always pull the plug, never the cable.
/ G E T S TA R T E D Power on your CITATION BAR / ADAPT / TOWER Plug one end of the AC power cord into the POWER connector on the back of your CITATION BAR / CITATION ADAPT / CITATION TOWER, then plug the other end to an AC (mains) outlet.
/ G E T S TA R T E D POWER Citation Tower Speaker Setup On the touch screen of your CITATION BAR / CITATION ADAPT / CITATION TOWER, press “Speaker Setup” > “Pairing” > “Subwoofer pairing” and follow the on-screen instructions to complete the setup. If the connection is unsuccessful, move the subwoofer no more than 5 meters away from your CITATION BAR / ADAPT / TOWER. Alternatively, press RESET to enter pairing mode and try again.
/ G E T S TA R T E D To remove the setup, press “Subwoofer pairing” on the touch screen of your CITATION BAR / ADAPT / TOWER again and follow the on-screen instructions.
/ SPECIFICATIONS • Frequency response: 35 ~ 125Hz • Signal-to-noise ratio: >80dB • Output power: 200W RMS • Power supply: 100-240V ~ 50/60Hz • Power consumption in sleep mode: <2.0Watts • 5G WISA transmitter power: <14dBm • 5G WISA modulation: OFDM, BPSK, QPSK, 16QAM • 5G WISA transmitter frequency range (varies by country or region): 5.15GHz-5.35GHz, 5.47-5.725GHz, 5.725-5.825GHz • Dimensions (W x H x D): 448 x 340 x 367 mm / 18” x 13” x 14” • Weight (Net): 14.
