User Guide GO+PLAY II ™ English Portable hi-fi speaker for iPhone/iPod iPhone not included 0170CSK - HK Go+Play II v5.
Regulations Important Safety Instructions Please read the following precautions before use: 12. Use only with the cart, stand, tripod, bracket or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 13.
English Harman Kardon Go + Play™ II Welcome Package contents Thank you for purchasing the Harman Kardon Go + Play II portable hi-fi speaker for iPhone/ iPod. This system has been designed to meet the highest audio-performance standards. The Harman Kardon Go + Play II system will meet all your listening and travel needs, allowing you to immerse yourself in your favorite music, wherever you are.
General Setup Battery Installation 1. Unpack the Harman Kardon Go + Play II system. 2. Place the appropriate nest into the docking station. 3. IMPORTANT: Turn the adjustable knob in the center of the docking station to match your specific iPhone/iPod model. 4. Place the iPhone/iPod into the docking station. 5. Connect the power supply into the “DC In jack”. 6. Plug the adapter into the wall outlet. 7. If using batteries is preferred, install eight (8) type D batteries into the bottom of the unit. 1.
English Listening to Music From an iPhone/iPod Remote Functionality 1. Press the “Power” button located on top of the Harman Kardon Go + Play II system to turn on the unit. 2. Select and play music using the controls on your iPhone/iPod or send commands to your iPhone/iPod with the Harman Kardon Smart Remote. (Remote-control functionality may vary depending on iPod model and firmware version). 3.
Troubleshooting Symptom Possible Problem Solution Note Symptom Sound Quality There is no sound coming from the Harman Kardon Go + Play II unit. Possible Problem Solution Note Audio source or source material may be the problem. Test the Harman Kardon Go + Play II unit with another source. Does the distortion occur with specific songs? If so, check the recording or record the source again. Volume level may be too high. Check volume of source.
Symptom Possible Problem Solution No power to unit. Make sure that your the wall outlet or power strip has power. Make sure that all switches for outlet/power strip are on and that all switches for the unit are on. Note Charging iPhone/iPod will not charge. If the Go + Play II unit is connected to a computer, make sure computer is on and the USB port has power. The iPhone/iPod is not making full contact with the docking station.
Harman Consumer Group, Inc. 8500 Balboa Boulevard, Northridge, CA 91329 USA 516.255.4545 (USA only) www.harmankardon.com Made in China. © 2009 Harman International Industries, Incorporated. All rights reserved. Harman Kardon is a trademark of Harman International Industries, Incorporated, registered in the United States and/or other countries. Harman Kardon Go + Play II and Atlas are trademarks of Harman International Industries, Incorporated. iPod and iTunes are trademarks of Apple Inc.