User manual

Example: To use the TV button to operate a sec-

ond VCR, first press the

TV Input Selector e

and the Mute Button at the same time until

the red light glows under the

TV Button e. Press

the

VCR Button e, followed by the three-digit

code for the specific model you wish to control.

Finally, press the

TV Button e again.

Resetting the Remote Memory

As you add components to your home theater system,

occasionally you may wish to totally reprogram the

remote control without the confusion of any commands,

macros or ”Punch-Through“ programming that you may

have done.To do this,it is possible to reset the remote

to the original factory defaults and command codes by

following these steps.However, once the remote is

reset, all commands or codes that you have entered will

be erased and will need to be reentered:

1. Press any of the

Input Selector Buttons e and

the

”O“ Button r at the same time until the

Program/SPL Indicator c begins to flash amber.

2. Press the

”3“ Button r three times.

3.The red LED under the

Input Selector e will go

out and the

Program/SPL Indicator c will stop

flashing and turn green.

4.The

Program/SPL Indicator c will remain green

until the remote is reset. Note that this may take a

while,depending on how many commands are in the

memory that need to be erased.

5.When the

Program/SPL Indicator c goes out,

the remote has been reset to the factory settings.

38 PROGRAMMING THE REMOTE

PROGRAMMING THE REMOTE