Users Manual Part 5

MULTIMEDIA 473
Headphones Operation
The headphones receive two separate channels
of audio using an infrared transmitter from the
video screens.
If no audio is heard after increasing the volume
control, there are a number of things that can
be done to troubleshoot the issue:
 Verify that the screen is turned on.
 Check to see that the channel is not muted.
 Make sure that the headphones are on.
 Verify that the headphone channel selector
button is on the desired channel. This button
switches between the audio of screen 1 and
screen 2.
 Install two new AAA type batteries in the
headphones.
Uconnect Theater Headphones
The headphone power indicator and controls
are located on the right ear cup.
NOTE:
Uconnect Theater must be turned on before
sound can be heard from the headphones. To
conserve battery life, the headphones will auto-
matically turn off approximately three minutes
after the Uconnect Theater system is turned off.
Changing The Audio Mode For Headphones
1. Ensure the remote control and the head-
phones are on the same channel.
2. Push the Home button on the remote
control.
3. When the Home menu appears on the
touchscreen, use the Arrow buttons on the
remote control to navigate to the available
modes and push the OK button to select the
new mode or use the Gesture Pad at the top
of the remote control.
Headphone Channel Selector Button
1 — Power ON/OFF Button
2 — Volume Control Wheel
3 — Channel Selector Button
9
20_RU_OM_EN_USC_t.book Page 473