User Manual for LUXASTR01 Revision Description of changes Note 1.0 Created 10 September.
Table of Content 1. Introduction............................................................................................................................................. 3 2. Specifications........................................................................................................................................... 3 Quick overview of Specification. ............................................................................................................ 3 Technical Specification .........
1 Introduction WiFi module LUXASTR01 is a single board WiFi solution based on Amlogic A113D Audio Precessor and Embedded Wireless LAN controller SOC(Which integrates quad-core ARM Cortex A53) and Ampak AP6398S RF module(Which integrates Broadcom BCM43598 single-chip IEEE802.11TM b/g/n /ac MAC/Baseband/Radio device). 2 Specifications Quick overview of Specification.
3 Mechanical overview Mechanical Dimension The maximum mechanical form factor of the module is shown below.
4 I/O specification Pin Configurations 5
5 WiFi RF Specification 2.4G The device operates strictly as a client in DFS channels. It does not support ad-hoc, Wi-Fi Direct Group Owner, Hotspot or any other peer-to-peer modes that may initiate a network in DFS channels.
5.
6 FCC & IC Statement FCC ID : APILUXASTR01 FCC Statement: Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
USERS MANUAL OF THE END PRODUCT: The end user has to be informed that the FCC radio-frequency exposure guidelines for an uncontrolled environment can be satisfied. The devices must be installed and used in strict accordance with the manufacturer's instructions as described in the user documentation that comes with the product The end user has to also be informed that any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment.
IC Statement: This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices. De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de radars de haute puissance sont désignés utilisateurs principaux (c.-à-d., ont la priorité) pour les bandes 5250-5350 MHz et 5650-5850 MHz et que ces radars pourraient causer du brouillage et/ou des dommages aux dispositifs LAN-EL. For indoor use only. Pour une utilisation en intérieur uniquement.
7. Antenna list No Antenna P/N Manufacturer Peak Gain(dBi) 2.4GHz 5.0GHz 1 NDX-181025 SOUTH STAR TECHNOLOGY 1.55dBi HONG KONG COMPANY LIMITED 3.32dBi 2 N12-7722-R0A SOUTH STAR TECHNOLOGY 3.19dBi HONG KONG COMPANY LIMITED 3.94dBi 3 N12-5672-R0A SOUTH STAR TECHNOLOGY 2.53dBi HONG KONG COMPANY LIMITED 3.
