User Manual Part 2

2-12

RF-7800B

SYSTEM SETUP AND TEARDOWN

2.6 INITIAL TURN-ON / CHECK

Once the system is installed, verify that the BGAN terminal is operational. Perform the following:

a. Make sure the data cable is connected to BGAN terminal and computer.

b. Make sure the power cable is connected to BGAN terminal and power source.

c. Use a web page to log into BGAN terminal using its Internet Protocol (IP) address.

Default is http://192.168.128.100.

d. If necessary, the network connection of a Microsoft Windows computer can be set up to accept a

dynamic IP address as follows (BGAN terminal acts as a Dynamic Host Configuration Protocol

(DHCP) server:

1. Select Start > Settings > Networks and Connections.

2. Select Local Area Connection and select Properties from the context menu.

3. Select the Transmission Control Protocol/Internet Protocol (TCP/IP) connection and select the

Properties button.

4. Select Obtain an IP address automatically from the General tab of the TCP/IP Properties page.

5. Select OK to close the TCP/IP Properties page and OK again to close the Local Area Connection

Properties page.