User Manual Part 2

2-3
RF-7800B
SYSTEM SETUP AND TEARDOWN
R
CAUTION
Avoid placing BGAN terminal near any source of heat such as
an open flame or cigarettes.
2.2.2 Dimension and Weight Information
Refer to Table 1-1 for the dimensions and weights.
2.2.3 Power Requirements
Refer to Table 1-1 for power requirements. Refer to Paragraph 1.9 for the various optional power cables available.
2.2.4 Grounding
Neither the RF-7800B-VU104 or RF-7800B-DU024 require mounting on a ground plane for performance.
2.3 UNPACKING AND REPACKING
Equipment is packed in corrugated boxes. A two-piece foam enclosure protects the equipment against corrosion and
rough handling. Boxes and packing materials should be retained in case the equipment is reshipped.
2.3.1 Unpacking
Perform the following procedure to unpack the BGAN terminal:
a. Inspect the exterior of the box for signs of damage during shipment. Document any problems and report
them to the proper authority.
b. Move the boxed equipment to the general location where it is to be installed.
c. After removing the equipment, check the contents against the packing slip to see that the shipment is
complete. Report discrepancies to Harris/RF Communications Product Service Department
(telephone: [phone], toll free: 866-264-8040, web: https://premier.harris.com/rfcomm).
2.3.2 Repacking
Perform the following procedure to repack the BGAN terminal:
a. Use the original box, if it was retained. If not, use a box that allows at least three inches of clearance on
all sides of the BGAN terminal components.
b. Use the original packing material, if it was retained. If not, use foam packing material to fill the space
between the BGAN terminal components and the box. Surround the entire unit with several inches of
foam packing material.
c. Use a good quality packing tape (or straps) to seal the box after closing.
2.4 BGAN TERMINAL SETUP
After receiving the USIM card from your BGAN service provider, install the card into the BGAN terminal.