User Manual
Table Of Contents
- 1 REGULATORY AND SAFETY INFORMATION
- 1.1 SAFETY SYMBOL CONVENTIONS
- 1.2 RF ENERGY EXPOSURE AWARENESS AND CONTROL INFORMATION FOR FCC OCCUPATIONAL USE REQUIREMENTS
- 1.3 COMPLIANCE WITH RF EXPOSURE STANDARDS
- 1.4 REGULATORY APPROVALS
- OCCUPATIONAL SAFETY GUIDELINES AND SAFETY TRAINING INFORMATION
- 1.6 COMMON HAZARDS
- 1.7 SAFE DRIVING RECOMMENDATIONS
- 1.8 OPERATING RULES AND REGULATIONS
- 1.9 OPERATING TIPS
- 2 SPECIFICATIONS
- 3 INTRODUCTION
- 4 UNPACKING AND CHECKING THE EQUIPMENT
- 5 PLANNING THE INSTALLATION
- 6 ANTENNA INSTALLATION
- 6.1 ANTENNA MOUNTING LOCATIONS
- 6.2 ANTENNA INSTALLATION PROCEDURES
- 7 FRONT-MOUNT RADIO INSTALLATION
- 8 REMOTE-MOUNT RADIO INSTALLATION
- 8.1 MOUNTING THE REMOTE-MOUNT RADIO
- 8.2 REMOTE-MOUNT RADIO’S DC POWER INSTALLATION
- 8.3 CONTROL HEAD INSTALLATION
- 8.3.1 General Information on the CH100 Control Head
- 8.3.2 General Information on the CH721 Control Head
- 8.3.3 Multi-Head Radio Installations
- 8.3.4 Control Head Mechanical Installation
- 8.3.5 Control Head-to-Radio CAN Cable Connections
- 8.3.6 Control Head Power Cable Installation
- 8.3.7 Using Vehicle Fuse and TTap Kit (Optional) Instead of Waterproof Inline Fuse Holder (Standard)
- 9 SPEAKER INSTALLATION
- 10 MICROPHONE ATTACHMENT
- 11 OPTIONAL CABLES AND CONNECTIONS
- 12 GPS NMEA-FORMATTED DATA CONNECTION
- 13 INITIAL POWER-UP TEST
- 14 PERFORMANCE TESTS
- 15 COMPLETE THE INSTALLATION
- 16 WARRANTY REGISTRATION
- 17 WARRANTY
14221-1200-4000, Rev. A
76
11.5 CH-721 MIC CONNECTOR PROGRAMMING CABLE CA-103541-001
CH-721 Mic Connector Programming Cable CA-103541-001 (4 feet long) can be used to program and
configure the CH-721 control head via its front-panel microphone connector. It has a female DB-9
connector on one end for connection to a PC’s serial port connector and a 17-pin Conxall-style connector
on the other end for connection to the head’s mic connector. Refer to the respective Software Release
Notes for programming and configuration information.
(Made From PS-CA-103541 Rev. A)
Figure 11-5: CH-721 Serial Programming Cable CA-103541-001
11.6 SPEAKER-ONLY OPTION CABLE CA-012349-007
Speaker-Only Option Cable CA-012349-007 is used when only speaker connections to a front-mount
radio must be made. Other connections to the 44-pin (DB-44) connector on the rear of the radio cannot
be made when this 20-foot cable is employed. It connects the radio’s high-power speaker audio output to
the 2-wire leads of the speaker. Refer to Section 9.1 on page 68 for the respective installation instructions.
Connector P1 mates to the 44-pin connector on the rear of the radio. Connector P2 mates to the speaker’s
2-pin connector.
(Made From PS-CA-012349 Sh. 10, Rev. G)
Figure 11-6: Speaker-Only Option Cable CA-012349-007
P1
ASSEMBLY DIAGRAM
WIRING DIAGRAM
P2
1
2
(Pin-Out
View)
P1
(Bottom
View)
P1
(Jackscrew
End
View)