User Manual
Table Of Contents
- INTRODUCTION
- BASIC SETUP
- BASIC OPERATIONS
- XG-100P Controls
- Top Display
- Main Display
- Menu Navigation
- Before First Time Use
- Power On and Set Volume
- Select Channel Bank
- Select Channel Using Knob
- Turn Encryption On or Off
- Select Zone Using Menus
- Make an Individual Call
- Make a Priority Call
- Select a New Talkgroup
- Use Talkaround to Bypass Repeater
- Start Scan
- Stop Scan
- Nuisance Delete
- View GPS Information
- Emergency Operation
- ADVANCED OPERATIONS
- PROGRAMMING
- REFERENCE
- GLOSSARY
- INDEX
102
XG-100
PROGRAMMING
5
This section provides information on front panel programming. Programming can
also be accomplished by creating a plan using a computer.
PROGRAMMING VIA CPA
The Communications Planning Application (CPA) is to be used for the bulk of
programming the XG-100P. Use USB cable, 10282-0410-A1.
Using the CPA you can fully program the XP-100P, including the programmable
button, switches and keys.
EDIT CHANNEL
Channels can be edited from the Channel Information (CH INFO) menu display, if
enabled using the CPA. Many of the displayed parameters can be modified here.
Parameters change, depending on the channel being a digital, analog or dual
channel. For receive, a dual channel allows you to receive both digital or analog
signals. When transmitting on a dual channel, you can only transmit either a digital
or analog signal, depending on how the channel is programmed.
1. At main display, use
for channel information
menu.
2. Use to scroll through
the programmed channel
settings.