User Manual
Table Of Contents
- INTRODUCTION
- BASIC SETUP
- BASIC OPERATIONS
- XG-100P Controls
- Top Display
- Main Display
- Menu Navigation
- Before First Time Use
- Power On and Set Volume
- Select Channel Bank
- Select Channel Using Knob
- Turn Encryption On or Off
- Select Zone Using Menus
- Make an Individual Call
- Make a Priority Call
- Select a New Talkgroup
- Use Talkaround to Bypass Repeater
- Start Scan
- Stop Scan
- Nuisance Delete
- View GPS Information
- Emergency Operation
- ADVANCED OPERATIONS
- PROGRAMMING
- REFERENCE
- GLOSSARY
- INDEX
14
XG-100
BASI C SE T UP
2
ASSEMBLE THE RADIO
a. Make sure batteries are charged per the charger manual (refer to
10515-0372-4010, supplied with the charger).
b. To attach optional clip, slide into groove in back of the radio above
battery compartment.
c. Lift clip, if installed, and slide top of battery into top of battery
compartment at the rear of the radio.
d. Press down on bottom side of battery until it snaps into place.
Radio may need to be set for battery type (Battery Settings).
CAUTION: Do not overtighten the antenna as damage could result.
WARNING: Only use Harris charger approved for battery chemistry.
Injury could occur from improper charger use.