User Manual
Table Of Contents
- INTRODUCTION
- BASIC SETUP
- BASIC OPERATIONS
- XG-100P Controls
- Top Display
- Main Display
- Menu Navigation
- Before First Time Use
- Power On and Set Volume
- Select Channel Bank
- Select Channel Using Knob
- Turn Encryption On or Off
- Select Zone Using Menus
- Make an Individual Call
- Make a Priority Call
- Select a New Talkgroup
- Use Talkaround to Bypass Repeater
- Start Scan
- Stop Scan
- Nuisance Delete
- View GPS Information
- Emergency Operation
- ADVANCED OPERATIONS
- PROGRAMMING
- REFERENCE
- GLOSSARY
- INDEX
42
XG-100
BASIC OPERATI ONS
3
EMERGENCY OPERATION
The XG-100P can be programmed to enable emergency mode. ‘Emergency’ text
displays on dispatcher console if an emergency signal is received from another
XG-100P on a digital channel.
Receiving an Emergency Call
When receiving an Emergency Call, an alert beep is present (if tones are enabled)
and an emergency indication is displayed.
When receiving an emergency
on a digital channel, the Unit
Identification (ID) appears in the
activity area.
While the emergency display is
active, you can press the PTT to
respond to the emergency
caller.
When receiving an emergency
on an analog channel, the radio
only indicates that it is receiving.