SDS

Safety Data Sheet
T.O.V. Varnish
SDS Revision Date:
06/16/2015
Page 5 of 12
Do not allow spills to enter drains or waterways.
Use good personal hygiene practices. Wash hands before eating, drinking, smoking or using toilet. Promptly remove
soiled clothing and wash thoroughly before reuse.
6.3. Methods and material for containment and cleaning up
Eliminate ignition sources, provide good ventilation, dike spill area and add absorbent earth or sawdust to spilled
liquid. Thoroughly wet with water and mix.
Collect adsorbent/water/spilled liquid mixture into metal containers and add enough water to cover. Consult local
state and federal hazardous regulation before disposing into approved hazardous waste landfills. Obey relevant law.
7. Handling and storage
7.1. Precautions for safe handling
Use non-sparking utensils when handling this material.
See section 2 for further details. - [Prevention]:
7.2. Conditions for safe storage, including any incompatibilities
Handle containers carefully to prevent damage and spillage.
Incompatible materials: Strong oxidizing agents and acids.
Avoid hot metal surface. Keep away from excessive heat and open flames. KEEP OUT OF REACH OF CHILDREN.
See section 2 for further details. - [Storage]:
7.3. Specific end use(s)
No data available.
8. Exposure controls and personal protection
8.1. Control parameters
Exposure
CAS No.
Ingredient
Source
Value
0000085-44-9
Isobenzofurandione
OSHA
TWA 12 mg/m3 (2 ppm)
ACGIH
TWA: 1 ppmS
NIOSH
TWA 6 mg/m3 (1 ppm)
Supplier
No Established Limit
0000096-29-7
Ethyl Methyl Ketone Oxime
OSHA
No Established Limit
ACGIH
No Established Limit
NIOSH
No Established Limit
Supplier
No Established Limit
0000115-77-5
PENTAERYTHRITOL (95%MIN)
OSHA
TWA 15 mg/m3 (total) TWA 5 mg/m3 (resp)
ACGIH
TWA: 10 mg/m3
NIOSH
TWA 10 mg/m3 (total) TWA 5 mg/m3 (resp)
Supplier
No Established Limit
0000136-52-7
Cobalt 2-Ethyl Hexanoate
OSHA
PEL 0.1 mg/m3