Installation Instructions

IntegrationandTest,RBS884Pico(850MHzand1900MHz)
• Speech Path
• 01, 03, 05, 07, 09, 11, 13, 15, 17, 19, 21, 23, 25, 27, 29, and 31
The ETB for T1 (24 channels) has 24 time slots: 01 to 24, where 09 is
used for CLC.
The ETB for E1 (32 channels) has 32 time slots: 00 to 31, where 00 is used
for frame synchronization and 16 is used for CLC.
For additional information about T1 and E1 PCM links, see Section 5.11.1
on page 5-62.
5.9.2 Establishment of Semipermanent Connections: Pico 8
50 MHz
Semipermanent connections through the radio select
or,RITSW,locatedin
the Pico 850 MHz CRI cabinet are made using the command `Radio interface
semipermanent path, initiate' (
RISPI
).
5.9.2.1 Format of the RISPI command (Radio interface semipermanent path, initiate): Pico 850 MHz
RISPI:TSLOT1=tslot1, TSLOT2=tslot2, <NAME=name>;
5.9.2.2 Parameters: Pico 850 MHz
TSLOT1=tslot1 A timeslot in a device. This is the first timeslot
to be connected.
TSLOT2=tslot2 A timeslot in a device. This is the second timeslot to
be connected to TSLOT1.
NAME=name A name for a semipermanent path. It
should be a
symbolic name consisting of 1–15 characters.
5.9.2.3 Function: Pico 850 MHz
The RISPI command initiates the connection of a semipermanent path
through the radio selector (RITSW). A device that owns a participating
timeslot must be in working
state, and if two different devices are involved,
they must be defined in the same EMRP. Note that a timeslot used by the
system for control signaling to the transmission radio interface or for frame
synchronization cannot
be connected.
1532-AE/LZB 119 3834 Uae Rev PA4 2001-04-04 5-55