Operator's Manual
Table Of Contents
- Front Cover
- Preface
- Table of Contents
- Welcome to the OpenSky Network
- Network Organization
- Getting Started
- Display Screen Functions
- How to set your Dwell Display Selection
- How to set your Operational Mode
- How to set your Active Profile
- How to set your Active Talkgroup
- How to Assign Priority to a Talkgroup
- How to Lock Out a Listen Group
- How to Unlock a Listen Group
- How to set your Scan Mode
- How to Change the Channel
- How to Enable or Disable Side Tones
- How to Change Screen Brightness
- Basic Radio Operations
- How to Turn Your Radio On
- How to Log On to the Network
- How to Read the Self-Test Results
- How to Turn Your Radio Off
- How to Change the Volume
- How to Take a Voice Call
- How to Make a Voice Call
- What the Beeping Means
- How to Place a Talkback Call
- How to Place an Emergency Call
- Advanced Radio Operations
- How to Re-Provision for an Emergency
- How to Place Talkaround Calls
- CH-103 Control Head
- VTac Vehicular Tactical Network
- Indexes and Tables
- I
- Index
Software Version OTP 5.07 M-803 Operator Manual I-ii
Indexes and Tables
Index
(OTP) OpenSky Trunked
Protocol, 9, 22, 37
25kHz RF channel, 7
active profile, 34, 39, 40, 41, 42,
45
Active Profile, 34, 39, 41, 42, 45
active scan mode
check or change, 49
ad hoc work group, 17
addressability, 2
ambient light sensor, 21, 22
analog equipment, 2, 4, 5, 6, 8, 9,
10, 12, 18, 20, 23, 37, 39, 66
analog radios, 2, 8
analog voice waves, 4
analog, compare to digital, 18
APCO Project 25 Common Air
Interface, 8, 9, 22, 37
APCO Project 25 Phase 1, 8, 9,
22, 37
ASCII, 23
asynchronous ASCII, 23
audible side tones, 34, 52
base station, 3, 6, 7
BIST
Error Code, 59
block out non-emergency voice
calls, 44
Booting message
mode change, 38
brightness
select setting, 53
Brightness Menu, 53, 54
brightness selection, 53, 54
brightness setting, 34, 53
Built-in Self-Test, 58, 59
busy signal, 62