User Manual

MM102225V1, Rev. B
5
TABLE OF CONTENTS
Page
APPENDIX L.................................................................................................................................................................96
RECORDED DATA SHEET ......................................................................................................................................96
FIGURES
Figure 3-1: Bolt Assembly Hardware............................................................................................................................ 20
Figure 3-2: Nylon Washer and Bolt Assembly.............................................................................................................. 20
Figure 3-3: Concrete Floor Mounting............................................................................................................................20
Figure 3-4: Bolt Assembly Used to Bolt Rack to Concrete Floor ................................................................................. 21
Figure 3-5: Raised Floor Rack Attachment................................................................................................................... 21
Figure 3-6: Possible Rack-Up of Tower Site Rack #1 For One To Ten Base Stations Plus Backup And ISM Radio
Options........................................................................................................................................................ 22
Figure 3-7: Possible Rack-Up of Tower Site Rack #2 With Separate TX/RX Antenna Option For Base Stations #1
To #4 Of Six Maximum Plus Backup Option............................................................................................. 23
Figure 3-8: HPA RF Input Connection.......................................................................................................................... 24
Figure 3-9: DCX RF Output Connection....................................................................................................................... 24
Figure 3-10: Wire Bundles with DCX and Base Station Alarm Wiring........................................................................ 25
Figure 3-11: DPS Alarm Punchblock Connector .......................................................................................................... 25
Figure 3-12: RS-485 Main Cable and Pigtail Plug Connected to DCX......................................................................... 26
Figure 3-13: RS-232 Connector from Alarm Module to Bird Power Monitor (VSWR)...............................................26
Figure 3-14: Cable Connecting the Tower-Top Amplifier Control Box to the Input port of the Multi-Coupler........... 27
Figure 3-15: Cable Tray Layout.................................................................................................................................... 27
Figure 3-16: DC Power Connection Found in Each Rack - Black (DC Return) and Red (-48 Volt) wires................... 28
Figure 3-17: -48 Volt Breaker Distribution Panel of the DC Power Supply - Red Wire............................................... 28
Figure 3-18: DC Return Distribution Bar - Black Wires............................................................................................... 29
Figure 3-19: Properly Labeled OpenSky Circuit Breakers in the Distribution Panel....................................................29
Figure 3-20: Single Point Ground That is Found on Each Rack ................................................................................... 30
Figure 3-21: Ground Bar ............................................................................................................................................... 30
Figure 3-22: Dual Antenna PolyPhasers (Surge Protectors)..........................................................................................31
Figure 5-1: 3-Channel Base Station with Tower Top Amplifier Block Diagram.......................................................... 35