User Manual

MM102225V1, Rev. B
62
7.3 T1 QUALITY LINK
Objective: The Cisco 3600 provides comprehensive monitoring capabilities for the T1
port that carries data traffic over the communications backbone. The showcontroller
command accumulates statistics over sixteen 15-minute intervals. This test does not form
part of the site acceptance testing but is included as a diagnostic tool to aid resolution of
link related issues.
STEPS ACTION MISCELLANEOUS
1.
Allow the Unit to operate with the T1
connected for at least 5 minutes.
2.
Using a PC connected to the Cisco
CONSOLE port, enter the following
command from the enabled prompt:
buck40sas# show contr t1 1/0 [CR]
21
The 3600 will respond with the Status
Information on the right.
T1 1/0 is up
Applique type is Channelized T1
Cable length is long gain36 0db
No alarms detected
Framing is ESF, Line Code is B8ZS, Clock
Source is Line
Data in current interval (741 seconds
elapsed):
0 Line Code Violations, 0 Path Code
Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs,
0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0
Severely Err Secs, 0 Unavail Secs
Data in Interval 1:
0 Line Code Violations, 0 Path Code
Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs,
0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0
Severely Err Secs, 0 Unavail Secs
Data in Interval 2:
0 Line Code Violations, 0 Path Code
Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs,
0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0
Severely Err Secs, 0 Unavail Secs
Continued
21
"Buck40", where used in this manual, is only an example of the applicable code.