User Manual

MM102225V1, Rev. B
8
NAME OF TOOL USE/COMMENTS
Soft Jaw Connector Pliers
Tightening or loosening N-type connectors
Crescent Pliers: M/A-COM Part Number 529-10 or Tessco Part
Number 83040
Superflex Antenna Cable
To convey antenna signals to equipment racks within a shelter
Torque Wrench
Tightening SMA connectors
Preset to 5/16-inch, 8 inch-pounds of torque: M/A-COM Part
Number 1055419-1 (2098-5065-54) or Tessco Part Number
14682, 1 Newton/Meter torque
Trash Bags
For removal of debris from site
Hammer Drill, ½” chuck
Used to drill holes for anchors in concrete floor
Set tool
Used to expand anchors in the floor
Basic hammer
Used with set tool to expand anchors in the floor
Crimpers
Used to crimp on lugs to ground wire and power leads
Greenlee Knock-Out tool
Used to punch out hole on top of rack for entry of ground wire
9/16” Socket
Used to secure rack to the floor and power leads to bus bar on
rack
½” Socket
Used to secure ground to bus bar
7/16” Socket
Used to bolt racks together
Tape measure
Used to measure proper distance from wall to rack
Soldering gun
Used to solder leads of control cable connector
Heat gun
For shrink tubing with control cable connector
12” wire ties
¾” anchors (tapcon)
1” bolts
Crimp on 1 hole lugs
Crimp on 2 hole lugs
T1 Crimper
AMP Hand Tool, Part Number 2-231652-0
Labeling System for field
use
Recommended unit: P-Touch Labeling System, Model PT-330
Insulating washers
Between floor and bottom of rack between anchor bolts and
rack
Service Monitor
HP 8920
Network Analyzer
HP 8752C (Used in conjunction with HP 8920 for Tower Top
Amplifier)