User Manual

MM102365V1 Rev. B
8.1.2 Configure Tower Radio
CONFIGURATION TABLE COMMANDS
at*addr 2 ISM address
at*ip 172.18.144.35 IP address
at*type 3 Radio type – Tower Radio
at*intv 10 RF interval
at*ppi 4 RF packets per interval
at&w Save configuration table
at*defdest1 Sets the default destination address for this device
at*udp6425 Sets the UDP port for AT processing
at*np0 Radio set to use fiber optic interface
ROUTING TABLE COMMANDS
at*rtrem * Remove any prior entries from table
at*rte 2,172.18.144.35,t,m,0 Routing entry
at*rte 1,172.18.144.34,b,n,0 Backhaul Router entry
at*rte 3,172.18.144.34,c,r,0 Cell Radio 3 entry
at*rte 4,172.18.144.38,c,r,1 Cell Radio 4 entry
at*rte 5,172.18.144.40,c,r,2 Cell Radio 5 entry
at*nms_target 0,10.137.0.31,14000,FF,1
at*nms_target 1,10.128.1.32,14000,FF,1
at*nms_port6103
at*nms_enable1
at*mssave Save routing table
atz Reboot Backhaul
RF TABLE COMMANDS
at*rfrem * Remove all entries from the RF table
at*rfe 0,an,11,5b8,0,3 RF entry for Cell radio 3
at*rfe 1,an,11,5b8,0,4 RF entry for Cell radio 4
at*rfe 2,an,11,5b8,0,5 RF entry for Cell radio 5
FREQUENCY LIST COMMANDS
at*fle 2412
at*fle 2426
at*fle 2440
at*fle 2454
at*fle 2467
47