User Manual

MM102365V1 Rev. B

9.4.5 Removing an RF Configuration Table Entry

Each entry in the RF Configuration Table corresponds to an RF link with another ISM radio. Use the

procedure below to remove a link address from the RF Configuration table.

The table is the responsibility of the Network Administrator. Entries are established or changed at the

Network Management Console, a terminal attached to the maintenance port, or remotely through the

10Base-T Ethernet port.

Example:

1. Type the RF table deletion string at*rfrem index at the network management console or maintenance

port where index is the RF link identifier of the ISM device whose entry you wish to delete (a number

from 0 to 5). For example: at*rfrem 0

2. Press the Enter key.

3. This sequence states the command: Remove the RF Configuration table entry for the ISM device at

RF Link 0.

4. The console confirms your change: OK

5. To save the change to non-volatile memory, type at*mssave <Enter>.

NOTE

Remember to save changes to Non-Volatile Memory.