User Manual

MM102365V1 Rev. B
Cell Site
GROUNDING KITS
COAXIAL CABLE
LDF5-50A
7/8" if length above 50'
1/2" if length below 50'
HOISTING GRIP
3
1
F4-NMNM-6 FSJ4-50B
(Optional - use with 7/8"
or larger cable)
ANTENNA TX/RX 800 MHz
(Model to be determined)
2
GROUNDING KITS
2
N(M) Connector
N(M) Connector
N(F) Connector
N(F) Connector
DC
Chassis
Ground
Chassis
Ground
Chassis
Ground
N(M) Connector
N(F) Connector
GROUNDING KITS
N(M) Connector
COAXIAL CABLE
LDF5-50A
7/8" if length above 50'
1/2" if length below 50'
HOISTING GRIP
3
1
2
GROUNDING KITS
2
2
COAXIAL CABLE
LDF5-50A
7/8" if length above 50'
1/2" if length below 50'
HOISTING GRIP
3
1
F4-NMNM-6 FSJ4-50B
(Optional - use with 7/8"
or larger cable)
ISM DIRECTIONAL ANTENNA
TX/RX 2.4 ISM Band
(Model to be determined)
GROUNDING KITS2
NOTES:
N(M) Connector
N(F) Connector
N(F) Connector
N(M) Connector
N(M) Connector
N(F) Connector
N(F) Connector
N(M) Connector
N(F) Connector
SINGLE CONTINUOUS LENGTH OF CABLE FROM ANTENNA
TO EQUIPMENT ROOM.
EACH GROUNDING KIT IS TO BE TIED TO THE MAIN GROUND
RUN.
GROUNDING KITS ARE TO BE INSTALLED BETWEEN THE LDF
CABLE AND THE TOWER AT THE TOP OF THE LENGTH
WHERE THE CABLE LEAVES THE TOWER AND AT 200 ft.
INTERVAL ON THE TOWER.
IF THE TOWER TO BUILDING LENGTH IS GREATER THAN 5ft.
INSTALL ANOTHER KIT OUTSIDE THE BUILDING ENTRANCE.
ONE HOISTING GRIP FOR EACH 200 ft. OF CABLE.
1
2
3
AC
F4-NMNM-6 FSJ4-50B
(Optional - use with 7/8"
or larger cable)
N(M) Connector N(F) Connector
F4-NMNM-6 FSJ4-50B
(Optional - use with 7/8" or
larger cable)
N(F) Connector
N(M) Connector
F4-NMNM-6 FSJ4-50B
(Optional - use with 7/8" or
larger cable)
N(M) Connector
N(F) Connector
(Refer to Quality Standards Manual
dwg# GQM0221 for grounding)
CELL SITE ANTENNA ASSEMBLY
Note: Diversity antenna system
shown. If not setup as diversity
system only one ISM antenna
would be used. The antenna
system shown only as an
example. The design engineer
or other responsible party will
define the actual build to
specifications for your system.
DC Power &
Battery Backup
Main AC Circuit
Breaker
ISM DIRECTIONAL ANTENNA
TX/RX 2.4 ISM Band
(Model to be determined)
TYPICAL CELL SITE ANTENNA ASSEMBLY
(ISM Typ Inst Dwg, Sh. 2, Rev. 101403)
82