User Manual

MM102365V1 Rev. B
1. REGULATORY AND SAFETY INFORMATION
1.1 REGULATORY INFORMATION
These devices generate RF electromagnetic energy during transmit mode. They are
designed for and classified as “Occupational Use Only” meaning they must be used only
during the course of employment by individuals aware of the hazards and the ways to
minimize such hazards. These devices are NOT intended for use by the “General
Population” in an uncontrolled environment.
x This device complies with Part 15 of the Federal Communications Commission (FCC) Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful
interference; and (2) this device must accept any interference received, including interference that
may cause undesired operation.
x The FCC does not require the user to obtain a station license for this radio equipment before
operating it.
x This is a professionally installed device with a fixed power level. Only antennas listed on the grant
must be used. Shorter cable lengths or cable types with less gain must not be substituted as a
replacement other than those tested and listed in this manual.
CAUTION
The antenna(s) used for this transmitter must be installed by a professional to provide a
separation distance of at least 32 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
x The operator is responsible at all times for the proper operation and maintenance of the equipment.
x No FCC license is required for personnel maintaining the equipment.
x FCC regulations state that the frequency, deviation, and power of a radio transmitter must be
maintained within specified limits. It is therefore recommended that the power level be checked
before the station is placed in service.
Use of this radio as described below will result in user exposure substantially below the FCC
recommended limits for human exposure to Radio Frequency Electromagnetic energy.
Before operating this radio:
x Do not operate this radio if any of the RF connectors are not secure or if open connections are not
properly terminated.
x Do not operate this radio near electrical blasting caps or in an explosive atmosphere.
8