User Manual

40
4. Press the
 key a second time to set the group to Priority 2. A is
displayed on line three.
Press
 a third time to set the group to Priority 1. A is displayed on line
three. The priority level section sequence only advances the group to the next
high priority level and stops at priority level 1. To select a lower priority level,
the group must be deleted from the scan list and then added back to the scan
list. Each new group added to the scan list starts at the lowest priority. If the
Priority 1 and Priority 2 groups are already set and a new group is assigned as
Priority 1 or Priority 2, the previously assigned group will change to non-
priority scanning. One of the following messages may be momentarily
displayed:
SCAN DIS
The radio is not programmed to scan.
FIXED P1
A Priority 1 group has been pre-
p
rogrammed into the radio. A
new Priority 1 group cannot be selected.
FIXD LST
A fixed scan list has been pre-
p
rogrammed into the radio. It is
not possible to change the list without reprogramming the radio.
NOTE
To quickly view multiple group scan status, press  then
slowly but consistently rotate the group knob. Each group
status will appear on the display.
System Model
1. With scan operation turned OFF, select the desired group to add to the
selected trunked system group scan list.
2. Press
. The current priority status of the group will be displayed in
column 10 of line three for a time-out period. If the group is not part of
the scan list the status will be blank.
3. While the status is displayed, press
 to add the group to the scan list.
is displayed on line three.
4. Press
 a second time to set the group to Priority 2. A is displayed on
line three.