User Manual

45
Sending an Individual Call (Trunked Mode Only)
Pre-Stored Individual Calls
The following procedures describe how to initiate and complete a Pre-Stored
Individual Call.
System Model
1. To select a pre-stored individual phone number, enter the individual call
mode using the
 key. is displayed. Then scroll through the list of
stored numbers using the
 or  key.
2. Press the PTT button; when the radio is clear to transmit,
turns ON,
turns OFF and the channel access tone sounds. Line one shows the called
individual's name if found in the list of stored individuals or LID
followed by the logical ID number of the unit being called. The message
*INDV* displays on line two.
Scan Model
1. To select a pre-stored individual number, enter the menu mode by using
the
 key. Scroll through the mode list using the  or  key.
2. Press
. is displayed. Scroll through the list of stored phone numbers
using the
 or  key until the desired number is displayed. Press .
3. Press the PTT button; when the radio is clear to transmit
turns ON,
turns OFF and the channel access tone sounds. Line one shows the called
individual's name or LID. The message *INDV* displays on line two.
Direct Dial Individual Calls (System Mode Only)
The following procedures describe how to initiate and complete a Direct Dial
Individual Call.
1. The individual call ID is not stored in the pre-stored list of call IDs but
the individual unit ID is known, it can be entered directly from the
keypad.
2. Press and hold the PTT button to transmit.
will turn ON, will turn
OFF, and the channel access tone will sound. Line one shows the called
individual's ID followed by the logical ID number of the unit being
called. The message *INDV* displays on line two. Proceed talking into
the microphone.