User Manual

47
Sending a Telephone Interconnect Call (Trunked Mode Only)
Pre-Stored Number
Use the following procedures to initiate and complete a Telephone
Interconnect call:
1. System Model: To select a previously stored phone number, press
.
Use the
or  keys to scroll through the list of stored numbers.
Scan Model: To select a previously stored phone number, press
. Use
the or  keys to select the menu option PHN CALL. Press the 
key again then use the
 or  keys to scroll through the list of pre-
stored numbers.
2. Press and release the PTT button. When the radio is clear to transmit,
turns ON,
turns OFF and the channel access tone sounds. Line one
shows the accompanying name selected from the list of stored numbers.
The message *PHONE* displays on line two. The radio then
automatically transmits the programmed number stored in the special call
queue.
3. A telephone ring will be heard from the speaker. When someone answers
the phone, press the PTT button and speak into the microphone. Release
the PTT button to listen to the callee. Unsuccessful interconnect signaling
returns the radio to the normal receive mode and the number remains
displayed until the special call is cleared or the time-out expires or
another group or system is selected. Terminate a call by pressing the
CLEAR/MONITOR button.
NOTE
In half-duplex mode, only one person may talk at a time. The
radio PTT button needs to be pressed in order to communicate
to the individual called and released for the individual called to
be heard.
Direct Dialing of Phone Calls (System Mode Only)
1. If the phone number is not stored in the pre-stored list of phone numbers,
but the phone number is known, it can be entered directly from the
keypad. Start by pressing the
. Then enter the required number from
the keypad.
NOTE
The last number directly entered can be recalled by first
pressing  then pressing the PTT button.