User Manual

51
until the system manager sends an activation message. Each radio that
receives and acknowledges the regrouping instructions is successfully
regrouped.
Pressing and holding the CLEAR/MONITOR button for 2.5 seconds toggles
the user into and out of the dynamic regroup groupset. A double beep will
sound for entry or exit. The display will indicate REGRP_0x where "x" is a
digit of 1 to 8 indicating the group (when dynamic regroup has been enabled
by the user). If the radio is in dynamic regroup and the user selects a group
that has not been regrouped, the display will show NO ENTRY. The radio
will be prevented from transmitting and receiving calls in this condition
except for scanned groups.
Emergency Operation
If the pre-programmed groupset on the currently selected system contains an
EMER/HOME group and the radio is in dynamic regroup, the radio will
declare the emergency on the currently selected dynamic group.
Macro Key Operation
Macro key operation permits the user to accomplish a series of keystrokes
with a single "macro" keystroke. Each Macro Key is capable of executing up
to twenty (20) keystrokes, to any push button input (i.e., keypad keys,
OPTION button, etc.). Each macro key can be pre-programmed to activate
when pressed or when released.
A macro key may also be pre-programmed to change the key stroke sequence
the next time the macro key is activated.
For detail operation and assignment of macro keys, contact your
communications supervisor or administrator.
PORTABLE DATA
The P7200 series portable radios, when operating in the EDACS
configuration, permit either voice or data calls to be transmitted or received.
The radio can handle only one type of call at a time; however, either data or
voice is selected transparently by the operator through normal usage of the
radio. Data communications is not supported in the conventional mode.
The radios can be connected to Mobile Data Terminals (MDT) or to a host
computer. Any RS-232 compatible device that supports the Radio Data
Interface (RDI) protocol (Version 1.91 or greater) may be connected to the
radio. Support for MDTs or host computers is a programmable option per
radio. Additionally, radios may also be programmed for data only operation
(no voice calls transmitted or received).