User Manual

53
• Emergency is declared by pressing the pre-programmed emergency
button.
• A group or system is changed.
Scan Lockout Mode
Following the transmission or reception of a data call, if scan is enabled,
scanning will stop temporarily (two independent pre-programmed times; after
a receive data call and after a transmit data call). During this time the scan
indicator will flash to indicate that scan is enabled but temporarily suspended.
This mode is normally exited when the pre-programmed time expires;
however, the following actions will terminate the scan lockout mode before
the timeout is completed:
• The CLEAR button is pressed. The PTT is pressed.
• The group or system is changed.
• Phone call mode is entered.
• Individual call mode is entered.
• A new emergency assignment has been received.
• An emergency is declared or cleared.
• An individual or phone call is received.
• An Agency, Fleet or System All Call is received.
•
 or  is pressed to toggle Scan ON or OFF.
Data Lockout Mode
During the voice call scan hang time (pre-programmed) the radio will not
receive data calls.