User Manual
Com-Net Ericsson Critical Radio Systems, Inc. 4
P.O. Box 2000
Lynchburg, Virginia 24501 MM101027V2
1-800-528-7711 (Outside USA, 804-592-7711) Printed in U.S.A.
To ensure that your exposure to RF electromagnetic
energy is within the FCC allowable limits for
occupational use, always adhere to the following
guidelines:
• DO NOT operate the radio without a proper antenna attached, as this
may damage the radio and may also cause you to exceed FCC RF
exposure limits. A proper antenna is the antenna supplied with this
radio by the manufacturer or an antenna specifically authorized by
the manufacturer for use with this radio.
• DO NOT transmit for more than 50% of total radio use time (“50%
duty cycle”). Transmitting more than 50% of the time can cause
FCC RF exposure compliance requirements to be exceeded. The
radio is transmitting when the “TX” light appears in the display. You
can cause the radio to transmit by pressing the “PTT” button.
• ALWAYS use Com-Net Ericsson authorized accessories (antennas,
batteries, belt clips, speaker/mics, etc). Use of unauthorized
accessories can cause the FCC RF exposure compliance
requirements to be exceeded.
• ALWAYS keep the antenna at least 1 cm (0.4 inches) away from the
body when transmitting to ensure FCC RF exposure compliance
requirements are not exceeded. To provide the recipients of your
transmission the best sound quality, hold the antenna at least 5 cm (2
inches) from mouth, and slightly off to one side.
The information listed above provides the user with the information
needed to make him or her aware of a RF exposure, and what to do to
assure that this radio operates within the FCC RF exposure limits of this
radio.