Install Manual Part 2

Figure 7 – Mounting Bracket and Mounting Bracket Hardware Kit

Radio Mounting Procedures

The following procedures are used to mount the radio.

1. Using the bracket as a template, mark and drill the mounting

holes using a No. 31 (1/8) drill bit. Be sure to leave enough

room at the rear of the radio unit for the cable connections and

airflow.

Be careful to avoid damaging some vital part (fuel tank,

transmission housing, etc.) of the vehicle when drilling mounting

holes. Always check to see how far the mounting screws will

extend below the mounting surface before installing.

If pilot holes must be drilled, remove all metal shavings from

drilling holes before installing screws.

2. Mount the bracket using the four 3/4” Phillips sheet metal screws

and spacers provided in the mounting bracket hardware kit.

(Refer to Figure 8.)

CAUTION