User Manual

Table Of Contents

Connect Option Cable

This section applies to installations that require an option cable. The

option cable (RPM 113 7674/1) is required if you are installing:

External Speaker

Internal/External Speaker Option

Car Horn Alert

Ignition Sense

External Modulation

External Demodulation

To connect the option cable to the radio:

1. Remove the two Phillips screws holding the plastic cover in

place, from the back of the radio, see Figure 5.

Figure 5 – Removing Plastic Cover

2. Insert the option cable through the hole left by removing the

plastic cover. This will allow the connector to fit through the

hole in the back of the radio.

3. Plug the option cable connector into J3 on the radio circuit

board.

4. Finally attach cable with the two Phillips screws.

STEP 4 – PROGRAM THE RADIO

All radios must be programmed with a radio personality. There are

many parameters in the P

ANTHER

300M mobile radio that need to be

setup and defined for the radio to operate appropriately for each

application. Conventional ProGrammer (TQ-3389 R9A or later) or

ProGrammer (TQ-3385 R9A or later) is the software used to create