Installation Manual

11
• Drills and circle cutters as follows:
!
No. 31 (1/8-inch) drill
!
1/2-inch drill or circle cutter
!
3/4-inch circle cutter, hole saw or socket punch
• Phillips and flat-blade screwdrivers
• No. 10 Torx driver
Torx is a registered trademark of CAMCAR Division TEXTRON, Inc.
STEP 3 – EQUIPMENT PREPARATION
Mounting
This section describes the radio preparation for installation. In most
applications, the following procedures should be completed before
the radio is mounted. Depending upon the mounting location, these
procedures could become very difficult after the radio is mounted.
The preparation list includes:
• Configuring the Internal Speaker Jumper
• Configuring the Ignition Sense Line Jumper
• Connecting the Option Cable to the Radio
Read through the procedures provided in this section. If you are
satisfied with the default factory jumper settings and your installation
does not require an option cable, skip this section and go to
STEP 4
– PROGRAM THE RADIO
on page 16.
Removing the Top Cover and Shield
The top cover and shield must be removed to change the Internal
Speaker jumper (JP701) or the ignition sense line jumper (JP600), to
connect the option cable to the radio.
1. The top cover is secured with three screws from the bottom of
the radio. Using a No. 10 Torx driver, loosen the three screws
! on the top of the radio as shown in Figure 2.
2. Remove the two control knobs from the front of the radio.
3. Pry the cover loose from the two tabs on the bottom of the radio.