Installation Manual

10
¾
1/2-inch drill or circle cutter
¾
3/4-inch circle cutter, hole saw or socket punch
•
Phillips and flat-blade screwdrivers
•
No. 10 Torx

driver
Torx is a registered trademark of CAMCAR Division TEXTRON, Inc.
STEP 3 – EQUIPMENT PREPARATION
Mounting
This section describes the radio preparation for installation. In most
applications, the following procedures should be completed before the radio
is mounted. Depending upon the mounting location, these procedures could
become very difficult after the radio is mounted. The preparation list
includes:
•
Configuring the Internal Speaker Jumper
•
Configuring the Ignition Sense Line Jumper
•
Connecting the Option Cable to the Radio
Read through the procedures provided in this section. If you are satisfied
with the default factory jumper settings and your installation does not
require an option cable, skip this section and go to STEP 4 – PROGRAM
THE RADIO on page 15.
Removing the Top Cover and Shield
The top cover and shield must be removed to change the Internal Speaker
jumper (JP701) or the ignition sense line jumper (JP600), to connect the
option cable to the radio.
1. The top cover is secured with three screws from the bottom of the
radio. Using a No. 10 Torx

driver, loosen the three screws

on the
top of the radio as shown in Figure 2.
2. Remove the two control knobs from the front of the radio.
3. Pry the cover loose from the two tabs on the bottom of the radio.