Installation Manual

13
Figure 3 – Factory Default Internal Speaker Jumper Setting (Enabled)
Configure the Internal Radio Speaker Jumper (JP701)
The P
ANTHER
300M radio is shipped from the factory with the internal
radio speaker jumper (JP701) set to 1-2 as shown in Figure 3. This setting
enables the internal radio speaker. Set the jumper to 2-3 if 1) only the
External Speaker is to be enabled or 2) the Internal/External Speaker option
is to be enabled.
Configure Ignition Sense Jumper (JP600)
The Ignition Sense line enables or disables transmit or car horn alert option
through the vehicle ignition switch. If the Ignition Sense option is desired,
Ignition Sense jumper JP600 must be set to 2-3. The P
ANTHER
300M radio
is shipped from the factory with the Ignition Sense jumper (JP600) set to 1-
2 as shown in Figure 4. This default setting disables the Ignition Sense
option. If your installation will not take advantage of the Ignition Sense
line, skip this section and proceed to the next section.
To use the Ignition Sense line in any application, the option cable must be