Installation Manual

15
Connect Option Cable
This section applies to installations that require an option cable. The option
cable (RPM 113 7674/1) is required if you are installing:
•
External Speaker
•
Internal/External Speaker Option
•
Car Horn Alert
•
Ignition Sense
•
External Modulation
•
External Demodulation
To connect the option cable to the radio:
1. Remove the two Phillips screws holding the plastic cover in place, from
the back of the radio, see Figure 5.
Figure 5 – Removing Plastic Cover
2. Insert the option cable through the hole left by removing the plastic
cover. This will allow the connector to fit through the hole in the back
of the radio.
3. Plug the option cable connector into J3 on the radio circuit board.
4. Finally, attach cable with the two Phillips screws.
STEP 4 – PROGRAM THE RADIO
All radios must be programmed with a radio personality. There are many
parameters in the P
ANTHER
300M mobile radio that need to be setup and
defined for the radio to operate appropriately for each application.
Conventional ProGrammer (TQ-3389 R9A or later) or ProGrammer (TQ-
3385 R9A or later) is the software used to create the personality for the
P
ANTHER
300M radio. The radio personality is a computer file that defines
all the operating parameters for the radio. For more information on
programming the P
ANTHER
300M radio, see the On-Line Help provided
with Conventional ProGrammer (TQ-3389 R9A or later) or ProGrammer
(TQ-3385 R9A or later). Typically, the radio is programmed before it is
installed in a vehicle.