User Manual

17
INSTALLATION
Installation of the J
AGUAR
725M mobile radio and control unit consists of:
•
Assembling and installing the weather resistant motorcycle case
assembly, including the adapter bracket, case/antenna mounting
bracket, and bottom case (previously assembled) to the motorcycle
mounting bracket (user supplied).
•
Installing the radio in the radio mounting bracket located inside the
weather-resistant case.
•
Installing the control unit, microphone, and speaker.
•
Installing the antenna.
•
Routing the power, control, and option cables.
•
Connecting all cables, including power, control, and option cables.
•
Installing the Headset Option.
•
Performing an operational check
All mounting hardware consists of stainless steel screws, locknuts, nuts, and
lockwashers to resist corrosion.
TOOLS REQUIRED
•
Socket wrench set U.S./metric with 3" extender
•
Open end wrench, adjustable
•
Wire clippers
•
TORX
®
BIT set, small metric
EQUIPMENT INSTALLATION
Assembling & Installing the Weather Resistant Case Assembly
The motorcycle Weather Resistant Case Assembly may be installed on
almost any motorcycle. Installation instructions provided here include
information for the Harley-Davidson Dyna and Road King models. Figure 5
illustrates installation on Harley-Davidson motorcycles. Refer to thIS
diagram during installation. Installation on other motorcycles is at the
discretion of the installer.