User Manual

Harley-Davidson Installation

1. Unpack the weather resistant motorcycle case, remove the key taped to

the top cover and open the case.

2. Refer to Figure 5 and verify all components shown in the diagram are

available.

3. Mount the adapter bracket on to the Dyna or Road King radio mounting

bracket (user supplied) using the 1/4-20 x 5/8 screws provided.

NOTE

The radio mounting bracket for the Dyna and Road King

models are different and require the use of different

mounting holes. See Figure 5 – Radio Installation, Harley-

Davidson Motorcycles.

4. Insert the power, control, and antenna cables through the square hole in

the case/antenna mounting bracket and then through the bottom case

assembly.

5. Mount the case mounting bracket and bottom case assembly onto the 4

resilient mounts using the serrated flange nuts and flat washers included

inside the weather resistant case. Refer to Figure 7, Mounting Bracket

and Case Assembly.

6. Refer to Figure 7 and connect the power cable to the radio. (Refer to

Cable Connections.)

7. Position the radio, fins up, inside the bracket in the bottom case

assembly and slide onto the arms. Lock in place using the TORX head

screws and lock washers (taped to the radio bracket).

8. Refer to Figure 7 – Radio Connections and connect the antenna and

control cables to the radio. (Refer to Antenna Installation.)

9. Mount the antenna to the case/antenna mounting bracket using the M3 x

16 mm pan head screws provided. Refer to Figure 6.

RADIO MOUNTING BRACKETS

Radio mounting brackets for all models of bikes are not available from the

factory. Should a special application arise for a custom-made radio

mounting bracket, it must be made using 0.125" steel (minimum). When

designing and mounting the bracket, corners/edges should be rounded to the

maximum extent possible.