User Manual

27
Typical Harley-Davidson Installation
1. Disconnect gas line from tank and drain gas into an approved container.
2. Remove cowling, gas tank, and fairing, if required, to gain access to the
triangular frame assembly, beneath the gas tank, to permit cable routing.
3. Push saddle support springs forward to release the saddle and tilt it
forward to gain access to the area beneath the saddle.
NOTE
The power cable is designed for negative ground systems
only. The power and control cable consists of three separate
cables: RED (positive), BLACK (negative), and a control
cable.
4. Pass the power and control cables through the square hole in the bottom
of the radio case assembly to the area beneath the saddle. See Figure 7
which shows cable routing under the center of the case assembly. Figure
11 shows the cabling underneath the saddle area. (Note the location of
the option cable and connector, not being used.)
5. Refer to Figure 12 and route the cables through the center of the
triangular frame assembly to the area at the rear of the control unit. The
cable may be routed along side existing cables and secured to them with
cable ties.
NOTE
It may be necessary to notch a portion of the cowling at the
control unit end and at the saddle area to provide entrance
and exit holes for the cable. The entrance and exit cutaway
holes are required to permit the cowling to be remounted
flush to the gas tank.
6. Route the control cable to the rear of the control unit and make the
connection to the right rear of the control unit as shown in Figure 13.
Any excess cable will reside beneath the saddle area. (The option and
accessory cable is shown connected to the left rear of the control unit).