User Manual

28
7. Re-examine cable routing and be sure that all cables are neatly routed
and secured with cable ties.
8. Install a cable clamp on saddle mounting bracket (left side) and secure
the power and control cables from the radio case assembly.
9. Route speaker leads from the control cable underneath the handlebar to
the rear of the instrument panel assembly in the vicinity of the speaker.
Secure to headlight cabling with cable ties. Excess cable should be
bundled and secured with cable ties behind the instrument panel
assembly.
NOTE
Refer to HEADSET INSTALLATION (OPTION) for
accessory cable routing instructions.
10. Connect speaker leads from accessory cable to speaker cable.
11. Connect negative power lead to the battery negative (-) terminal.
12. Connect positive power lead to the battery positive (+) terminal.
13. Reinstall gas tank, cowling, and secure saddle.
14. Verify all electrical connections: radio, control unit, antenna, option
switch, speaker, and battery.
15. Close and lock radio case assembly.